Antenna Overview

Overview

This article is in a list format that may be better presented using prose. You can help by converting this section to prose, if appropriate.

Antennas have practical uses for the transmission and reception of radio frequency signals (radio, TV, etc.). In air, those signals travel very quickly and with a very low transmission loss. The signals are absorbed when moving through more conducting materials, such as concrete walls, rock, etc. When encountering an interface, the waves are partially reflected and partially transmitted through.

A common antenna is a vertical rod a quarter of a wavelength long. Such antennas are simple in construction, usually inexpensive, and both radiate in and receive from all horizontal directions (omnidirectional). One limitation of this antenna is that it does not radiate or receive in the direction in which the rod points. This region is called the antenna blind cone or null.

There are two fundamental types of antenna directional patterns, which, with reference to a specific three dimensional (usually horizontal or vertical) plane are either:

1. Omni-directional (radiates equally in all directions), such as a vertical rod or
2. Directional (radiates more in one direction than in the other).

In colloquial usage "omni-directional" usually refers to all horizontal directions with reception above and below the antenna being reduced in favor of better reception (and thus range) near the horizon. A "directional" antenna usually refers to one focusing a narrow beam in a single specific direction such as a telescope or satellite dish, or, at least, focusing in a sector such as a 120° horizontal fan pattern in the case of a panel antenna at a Cell site.

All antennas radiate some energy in all directions in free space but careful construction results in substantial transmission of energy in a preferred direction and negligible energy radiated in other directions. By adding additional elements (such as rods, loops or plates) and carefully arranging their length, spacing, and orientation, an antenna with desired directional properties can be created.

An antenna array is two or more simple antennas combined to produce a specific directional radiation pattern. In common usage an array is composed of active elements, such as a linear array of parallel dipoles fed as a "broadside array". A slightly different feed method could cause this same array of dipoles to radiate as an "end-fire array". Antenna arrays may be built up from any basic antenna type, such as dipoles, loops or slots.

The directionality of the array is due to the spatial relationships and the electrical feed relationships between individual antennas. Usually all of the elements are active (electrically fed) as in the log-periodic dipole array which offers modest gain and broad bandwidth and is traditionally used for television reception. Alternatively, a superficially similar dipole array, the Yagi-Uda Antenna (often abbreviated to "Yagi"), has only one active dipole element in a chain of parasitic dipole elements, and a very different performance with high gain over a narrow bandwidth.

An active element is electrically connected to the antenna terminals leading to the receiver or transmitter, as opposed to a parasitic element that modifies the antenna pattern without being connected directly. The active element(s) couple energy between the electromagnetic wave and the antenna terminals, thus any functioning antenna has at least one active element.

An antenna lead-in is the medium, for example, a transmission line or feed line for conveying the signal energy between the signal source or receiver and the antenna. The antenna feed refers to the components between the antenna and an amplifier.

An antenna counterpoise is a structure of conductive material most closely associated with ground that may be insulated from or capacitively coupled to the natural ground. It aids in the function of the natural ground, particularly where variations (or limitations) of the characteristics of the natural ground interfere with its proper function. Such structures are usually connected to the terminal of a receiver or source opposite to the antenna terminal.

An antenna component is a portion of the antenna performing a distinct function and limited for use in an antenna, as for example, a reflector, director, or active antenna.

Parasitic elements have no direct electrical connection to the antenna terminals, yet they modify the antenna pattern. The parasitic elements are immersed in the electromagnetic waves and fields around the active elements, and the parasitic currents induced in them interact with the original waves and fields. A careful arrangement of parasitic elements, such as rods or coils, can improve the radiation pattern of the active element(s). Directors and reflectors are common parasitic elements.

An electromagnetic wave refractor is a structure which is shaped or positioned to delay or accelerate transmitted electromagnetic waves, passing through such structure, an amount which varies over the wave front. The refractor alters the direction of propagation of the waves emitted from the structure with respect to the waves impinging on the structure. It can alternatively bring the wave to a focus or alter the wave front in other ways, such as to convert a spherical wave front to a planar wave front (or vice-versa). The velocity of the waves radiated have a component which is in the same direction (director) or in the opposite direction (reflector) as that of the velocity of the impinging wave.

A director is a parasitic element, usually a metallic conductive structure, which re-radiates into free space impinging electromagnetic radiation coming from or going to the active antenna, the velocity of the re-radiated wave having a component in the direction of the velocity of the impinging wave. The director modifies the radiation pattern of the active antenna but there is no direct electrical connection between the active antenna and this parasitic element.

A reflector is a parasitic element, usually a metallic conductive structure (e.g., screen, rod or plate), which re-radiates back into free space impinging electromagnetic radiation coming from or going to the active antenna. The velocity of the returned wave having a component in a direction opposite to the direction of the velocity of the impinging wave. The reflector modifies the radiation of the active antenna. There is no direct electrical connection between the active antenna and this parasitic element.

An antenna coupling network is a passive network (which may be any combination of a resistive, inductive or capacitive circuit(s)) for transmitting the signal energy between the active antenna and a source (or receiver) of such signal energy.

Typically, antennas are designed to operate in a relatively narrow frequency range. The design criteria for receiving and transmitting antennas differ slightly, but generally an antenna can receive and transmit equally well. This property is called reciprocity.

Active antenna

http://en.wikipedia.org/wiki/Antenna_(radio)

Antenna

An antenna is a transducer designed to transmit or receive electromagnetic waves. In other words, antennas convert electromagnetic waves into electrical currents and vice versa. Antennas are used in systems such as radio and television broadcasting, point-to-point radio communication, wireless LAN, radar, and space exploration. Antennas usually work in air or outer space, but can also be operated under water or even through soil and rock at certain frequencies for short distances.

Physically, an antenna is an arrangement of conductors that generate a radiating electromagnetic field in response to an applied alternating voltage and the associated alternating electric current, or can be placed in an electromagnetic field so that the field will induce an alternating current in the antenna and a voltage between its terminals. Some antenna devices (parabolic antenna, Horn Antenna) just adapt the free space to another type of antenna.

Thomas Edison used antennas by 1885. Edison patented his system in U.S. Patent 465,971 . Antennas were also used in 1888 by Heinrich Hertz (1857-1894) to prove the existence of electromagnetic waves predicted by the theory of James Clerk Maxwell. Hertz placed the emitter dipole in the focal point of a parabolic reflector. He published his work and installation drawings in Annalen der Physik und Chemie (vol. 36, 1889).


Antenna

http://en.wikipedia.org/wiki/Antenna_(radio)

Wireless ad hoc network

Wireless ad hoc network


A wireless ad hoc network is a decentralized wireless network.[1] The network is ad hoc because each node is willing to forward data for other nodes, and so the determination of which nodes forward data is made dynamically based on the network connectivity. This is in contrast to wired networks in which routers perform the task of routing. It is also in contrast to managed (infrastructure) wireless networks, in which a special node known as an access point manages communication among other nodes.

The earliest wireless ad hoc networks were the "packet radio" networks (PRNETs) from the 1970s, sponsored by DARPA after the ALOHAnet project.

Application

The decentralized nature of wireless ad hoc networks makes them suitable for a variety of applications where central nodes can't be relied on, and may improve the scalability of wireless ad hoc networks compared to wireless managed networks, though theoretical[2] and practical[3] limits to the overall capacity of such networks have been identified.

Minimal configuration and quick deployment make ad hoc networks suitable for emergency situations like natural disasters or military conflicts. The presence of a dynamic and adaptive routing protocol will enable ad hoc networks to be formed quickly.

Wireless ad hoc networks can be further classified by their application:

* mobile ad hoc networks (MANETs)
* wireless mesh networks
* wireless sensor networks.


Wireless ad hoc network


http://en.wikipedia.org/wiki/Wireless_ad_hoc_network